Модули и компьютеры на базе NXP i.MX6/6UL/7, TI AM335x "Sitara"

Модули на базе ARM, PowerPC, QorIQ, промышленные компьютеры и терминалы

CANopen, интерфейсы CAN-USB, PLC на базе TriCore, ColdFire, PPC, XC16x

Адаптеры PCAN для подключения шины CAN к PC

Внимание! Компания Arm Keil приостановила работу с российскими компаниями на неопределенный срок C/C++ компиляторы, симуляторы, IDE, RTOS, оценочные платы и эмуляторы

Внимание! Компания Arm Keil приостановила работу с российскими компаниями на неопределенный срок Инструментальные средства разработки и отладки для ARM контроллеров

Средства разработки для AURIX, TriCore, Power Architecture, Cortex, ARM, C166/ST10, XE166/XC2000 и SH-2A

электротехническое оборудования Siemens и Moeller, системы бесперебойного питания Maserguard и SPower, маркировка, кабельные наконечники, инструмент

+ Увеличить

The PCAN-USB X6 is a CAN FD adapter for the USB port which allows the connection of up to 6 CAN FD or CAN busses. The device is therefore best suited for working with multiple CAN networks like the use in test benches with hardware-in-the-loop (HIL) simulations for motor vehicles or in the product line testing of CAN-based products.

The PCAN-USB X6 is installed in an aluminum profile casing and is shipped in versions with D-Sub connectors or M12 circular connectors. Especially the M12 version is suitable for use in harsh environments. In addition, a galvanic isolation of up to 300 Volts between the PC and the CAN side is guaranteed for the decoupled versions.

The new CAN FD standard (CAN with Flexible Data rate) is primarily characterized by higher bandwidth for data transfer. The maximum of 64 data bytes per CAN FD frame (instead of 8 so far) can be transmitted with bit rates up to 12 Mbit/s. CAN FD is downward-compatible to the CAN 2.0 A/B standard, thus CAN FD nodes can be used in existing CAN networks. However, in this case the CAN FD extensions are not applicable.

The monitor software PCAN-View and the programming interface PCAN-Basic for the development of applications with CAN connection are included in the scope of supply and support the new standard CAN FD.

ISO / Non-ISO CAN FD:

Since the first implementations of CAN FD, the protocol has been improved and is now included in the standard ISO 11898-1. The revised CAN FD standard is not compatible with the original protocol. 

PEAK-System takes this into account by supporting both protocol versions with their CAN FD interfaces. If required, the user can switch to the CAN FD protocol used in the environment by software („Non-ISO“ and „ISO“). Devices delivered until February 2015 need a firmware update for this functionality. If you are interested and for further information, please contact